HF HF-LPT230 User Manual

http://www.iotworkshop.com 1 Copyright © 2013 . All rights reserved
High Flying Wi-Fi Module
Operation Guide
This document is applicable to the following series of products. This article
uses HF-LPT230 as an example to introduce the main software functions. The
differences will be specified. For the hardware description of the product and
some software functions, please refer to the user manual.
2.4GWi-Fi
HF-LPB130
HF-LPT230
HF-LPT130A
HF-LPT130B
HF-LPT330
HF-LPB135
2.4GWi-Fi
+BLE
HF-LPC300
HF-LPC330
2.4G+5G
Wi-Fi
HF-LPD100
HF-LPD130
2.4G+5G
Wi-Fi
+BLE
HF-LPF100

HF HF-LPT230 Specifications

General

Wireless Standards	802.11 b/g/n
Data Rate	Up to 150 Mbps
Frequency Band	2.4 GHz
Interface	Ethernet
Operating Voltage	3.3V
Security	WEP, WPA, WPA2
Power Supply	DC 5V
Weight	100g

Summary

SERIAL PORT SETTINGS

SecureCRT Serial Port Tool SecureCRT

Instructions for downloading and installing SecureCRT for serial port communication and establishing a connection.

Setting Serial Port Parameters

Configuration of serial port parameters like baud rate, data bits, and parity in SecureCRT for module communication.

TEST CASE

Transparent Transmission of UART and Wi-Fi Module in AP Mode

Transparent Transmission of UART and Wi-Fi Module in STA Mode

Sending AT Commands in Network Mode

FIRMWARE UPGRADE

Serial Port Firmware Upgrade

Procedure for upgrading firmware via serial port using SecureCRT, including baud rate settings and bootloader entry.

Internal Web Page Firmware Upgrade

Steps to upgrade firmware and customized webpage via the module's internal web interface.

External Configuration Web Page Firmware Upgrade

Accessing and using the external configuration web page for firmware and module parameter updates.

HF Udate Mass Production Tool Mode Upgrade

AT+UPURL Command Mode Upgrade

DEBUG INFORMATION FUNCTION

Serial Port Log Information Output Enable

HF-LPCX30/HF-LPF100 MODULE BLE THROUGHPUT