4.3. External Configuration Web Page Firmware Upgrade
If PC direct connect to module’s hot spot (IP: 10.10.100.254) or the module is
connected to the router, use the IP address assigned to the module by the router (for
example: http://192.168.83.131) to enter the external configuration page of the module.
Note：HF-LPX30 series has 1MB and 2MB Flash difference, and the content of
external web pages is different. See the user manual for details.
4.4. HF Udate Mass Production Tool Mode Upgrade
Download the mass production upgrade tool from High Flying official website.
http://www.hi-flying.com/download-center-1/applications-1/download-item-production
-tool
Open HFUpdate to load the upgrade program. In this way, the LAN OTA needs to
shut down the computer's firewall and leave only one network card.
◆ Method 1: Manually configure the module and PC to connect to the same router
(the way to configure the router can use the method mentioned above), enter the
AT+OTA command on the serial port or network mode of the module to perform
the upgrade operation.
To Next Page
Loading...
Need help?
General
