To Next Page

To Previous Page

reserved

3.2. Transparent Transmission of UART and Wi-Fi Module in STA Mode

The test topology is as follows:

First, you need to configure the module to connect to the router. The HF-LPT230 supports

multiple ways to configure the connection router. The detailed options are as follows.

Method 1: Web page configuration.

⚫ PC Wi-Fi Direct Module AP hot spot, enter 10.10.100.254 to log in to the

management page, enter the username admin and password admin, change the

mode selection to STA, and fill in the information of the AP. After the setting is

completed, the restart takes effect.

Questions and Answers:

Need help?

Do you have a question about the HF HF-LPT230 and is the answer not in the manual?

HF HF-LPT230 Specifications

General