HID EH400 User Manual

Edge is the next evolution in access control hardware solutions. A true IP solution that meets the demands of open architecture, IP-centric
environments, Edge provides fully distributed intelligence and decision making right to the door, leveraging the IT infrastructure to the
maximum extent possible. Wire the Edge device to Hi-O interface modules to provide connectivity to electronic door components and
access control readers.
Hi-O involves devices with built-in intelligence and a CANbus that links all the devices together. Hi-O CANbus data trafc can be password
protected and encrypted, or both. Each Hi-O device (such as the push plate, electric strike, card reader, door operator) is connected to the
CANbus by a single, four-wire cable. Two of the wires supply power and the other two are used for data communication.
Specications
CONNECTION PARAMETER CONDITIONS VALUE
OPERATING
TEMPERTURE
CABLE LENGTH
PoE Power
(input)
Voltage - Nominal - 48 VDC
32° - 122°F
(0° - 50° C)
Hi-O CAN Bus
= 30 ft (9 m) - 22 AWG ● 0.65mm ● 0.33mm
2
= 75 ft (23 m) - 18 AWG ● 1.02mm ● 0.82mm
2
RJ45 = 328 ft (100 m) - Category 5 K
Current - Normal Standby
Condition (NSC)
CAN PWR - not loaded 75 mA
Current - Maximum CAN PWR - max load 275 mA
+DC (input)
Voltage - 12 VDC - 24 VDC
Current - Normal Standby
Condition (NSC)
12 VDC
CAN PWR disconnected
190 mA
Current - Normal Standby
Condition (NSC)
24 VDC
CAN PWR disconnected
110 mA
Current - Maximum 12 VDC 2.2 A
Current - Maximum 24 VDC 2.1 A
CAN PWR
(output)
Voltage - Nominal PoE 24 VDC
Current - Maximum PoE 300 mA
Voltage - Nominal + DC + DC
Current - Maximum + DC 2 Amp - AUX limited
Edge
EdgeReader® and EdgePlus®
Models: EH400, EHR40, EHRP40, EH400-K
ER40C, ERP40C
InstallatIon GuIde
82000-920, Rev A.1
December 10, 2009
© 2009 HID Global Corporation. All rights reserved.
15370 Barranca Parkway
Irvine, CA 92618-2215
USA
DRAFT

HID EH400 Specifications

General

Brand	HID
Model	EH400
Category	Network Card
Language	English

Summary

Product Specifications

Installation and Wiring

Mounting

Details the physical mounting of the Edge device, including junction box considerations.

Wiring Connections

Illustrates the wiring diagram for the Hi-O device and lists connection points.

Edge Device Installation

Install Edge to Backplate

Provides visual steps and component details for mounting the Edge device onto its backplate.

Device Configuration and Connectivity

Contacting Edge Device

Describes methods for connecting to the Edge device, including Direct Connect and OPIN application.

Configure Edge Device

Instructions on how to configure the Edge device using a web browser and login credentials.

Hi-O Interface Modules

Lists available Hi-O interface modules, their descriptions, and corresponding part numbers.

Regulatory Compliance

UL Compliance

Details UL requirements for power supplies, electrical codes, and device listing.

FCC and Canada Radio Certification

Covers FCC/Canada compliance, including interference conditions and user authority.

CE Marking

States compliance with essential requirements for radio and EMC directives.

Japan MIC and Taiwan DGT/NCC

Provides regulatory compliance statements for Japan (MIC) and Taiwan (DGT/NCC).