Need help?Do you have a question about the HID VertX EVO V1000 and is the answer not in the manual?
General| Operating Voltage | 12-24 VDC |
|---|---|
| Operating Humidity | 5% to 95% non-condensing |
| Inputs | 8 supervised inputs |
| Outputs | 4 relay outputs |
| Processor | 32-bit RISC |
| Memory | 8 MB Flash |
| Operating Temperature | 0°C to 50°C |
| Communication Ports | Ethernet, RS-485 |
| Reader Ports | RS-485 |
| Memory Capacity | 50, 000 cardholders |
Instructions for verifying the battery jumper and RS-485 termination jumper settings on the V1000 controller before installation.
Provides wiring instructions for the VertX EVO V1000, including network connection, power, alarm inputs, and RS-485 connections.
Details the general-purpose output connections on the VertX EVO V1000, showing pin locations for outputs and noting relay dry contact ratings.
Explains analog input connections for functions like REX and door monitor, detailing pin locations and default configurations for switches and supervision.
Describes communication setup using the browser-based Configuration GUI, including login, network setup, and host communication parameters.
Provides methods for validating the VertX installation, field wiring, and discovered devices, displaying inputs, outputs, and host status.
To Next Page
