July 2016 Page 19 of 25
see
VertX EVO V1000 User Guide, 71000-901, Rev. A.4
A.8 Firewall
If the VertX controller is being installed where it communicates through a firewall, then the
firewall may need to be configured to allow TCP data transfer on the specified port(s).
1. Before starting, ensure that any pop-up blocker software is disabled on the
computer.
2. Open the following ports on the firewall.
connection_port (4070) TCP outbound. This port must be open on the Host
computer.
listen_port (4050) TCP incoming. This port must be open when using selected
applications.
If you are not familiar with configuring a firewall for a network, contact the Network/IT
administrator or manager.
CAUTION: If the firewall is not configured properly the controller may not communicate
with the host.
To Next Page
Loading...
