July 2016 Page 17 of 25
see
VertX EVO V1000 User Guide, 71000-901, Rev. A.4
A.4 System Time
System Time provides the ability to view and set the date, time, and time zone values on the
controller.
Upon initialization, Date, Time, Time Zone and TZ fields will be populated with the current
system settings. The date displayed (non-text box) will be updated approximately every 30
seconds.
The Time Zone field provides a drop-down menu. One of the options in the Time Zone drop-
down menu is Custom Time Zone. If Custom Time Zone is selected, the TZ text box will be
enabled. Otherwise, the TZ is associated with the Time Zone field.
A.5 Update System
Update System allows the user to update the firmware on the interface panel. During a
download the interface panel image flashes between grey and yellow. When a download
completes the image color changes to green for successful or red for failure. If the download
fails, view a tool tip with the error status code by hovering your mouse over the image in
question.
Initially, all of the interface panels are selected by default to be updated.
Note: Depending on the VertX controller and system, it may take several minutes to
complete a download.
A.6 Battery Replacement
Do not replace the battery while power is applied to the VertX EVO Controllers.
Remove the cover.
Insert the battery (with the + (positive) side facing upwards) under the prongs, lowering the
opposite side into place. Reinstall the cover.
To remove the battery, remove cover, lift the side opposite from the prongs first and slide
the battery out of place away from the prongs. Reinstall the cover.
To Next Page
Loading...
