3.3.5 Calibrate sensors
The sensors should be calibrated after a firmware update, an ink cartridge change, or if you see the print is
not well-centered on the card. For example, if a white band is visible in the border of the card. Over time,
there can be stains on the LED or on the sensor and calibrating the sensors should overcome these types of
issues.
Place a blank card in the hopper, then click Calibrate to perform the task. When the calibration is in
process, status messages are displayed below the Calibrate button.
PLT-04368, A.0 31 August 2020
Powering
Trusted Identities
HID® FARGO® INK1000
Windows User Guide
To Next Page
Loading...
