ALTIWARE SERIES
TABLE OF CONTENTS
33
english
axis
TABLE OF CONTENTS
34
english
SETTING THE DAILY ALARM
1. Choose the TIME ZONE you wish to program an alarm for in the TIME OF DAY screen.
2. Starting in ALARM mode.
3. SELECT the alarm you wish to program using the S2 key.
4. PRESS & HOLD the S4 key to enter the programming sequence.
5. ADJUST the HOURS, MINUTES, TIME ZONE and CHIME using the S1 and S2 key.
6. SET and ADVANCE from variable to variable using the S3 key.
7. EXIT SETTING SEQUENCE using the S4 key.
NOTE: The CHIME is a single beep each time a key is pressed and a single beep at the start
of each hour. The KEY PRESS CHIME is useful if you are trying to operate the watch under
circumstances where it is difficult to look at the watch to confirm that an action has taken
place when a key is pressed.
RESETTING THE INSTRUMENT
To RESET the instrument back to its default values PRESS the S1, S2, S3 and S4 keys down at the
same time. The display will light up showing all segments followed by a sequence of screens showing
various numbers. The display will then automatically change to the TIME OF DAY screen at 12 o’clock
on the first of January.
Resetting the instrument will clear any information stored in the instrument. This should be done only
as a last resort.
DAILY ALARM
SPECIFICATIONS AND RANGES
GENERAL
Operational Temperature -10C to +50C/ 14F to 122F
Water Resistance 3ATM
Watch Battery CR 2032 3v Lithium
ALTIMETER
Range -703 to +9158m / -2305 to +30,045f
Resolution 1m / 1f
20 Memories with Date, Time and Altitude
THERMOMETER
Range -10 to +50C / +14 to +122F
Resolution 0.1C/0.1F
COMPASS
Resolution of 1 degree
Bearing direction in degrees and half-cardinal points
BAROMETER
Range 300 to 1100mbar
Resolution 1mbar
CHRONOGRAPH
Range 24 hours
Resolution 0.01 second for first hour; 1.0 second for hours 2-23
CHRONOGRAPH LOG
100 Laps/Splits
30 Runs/Workouts showing Lap/split times, Best Lap/Split, Average Lap/Splits
To Next Page
Loading...