59
Password Setting - Changing your WebGUI password
Under Password Setting type your new password and confirm it, then click submit.
Email Setting
The following topics are covered under email:
SMTP Setting
Adding Recipients
You can set the controller to send an email out to recipients of your choosing when
certain events (refer to Event Tab) trigger.
SMTP settings
To set up email alerts:
1. Check the Enable Event Notification box.
2. Enter the ISP server address name or SMTP name
3. Type in the email address of the sender (email account that is going to send the
alert)
4. Type in the account name and password of the sender
5. Type in the SMTP port (default: 25)
6. Check support SSL box if SSL is supported by your ISP (port value will change to
465, refer to your ISP if you have a specific SMTP port.
Note: After you click ‘Change Setting’ the password box will become blank.
To Next Page
Loading...
