HighPoint RocketStor 6414TS - Utilizing the Health Inspector Scheduler

33
To access the SMART attributes of an individual disk:
1. Log in to WebGUI (default user: RAID password: hpt).
2. Select the proper controller using the drop down menu on the top left.
3. Click the SHI tab.
4. Click SMART on the desired disk.
5. Click Enable to enable SMART monitoring.
Disabling SMART monitoring
You have the option the disable SMART monitoring on each individual disk:
1. Select the proper controller using the drop down menu on the top left.
2. Click the SHI tab.
3. Click SMART on desired disk.
4. Click Disable.
Note: Disabling SMART will prompt the Storage Health Inspector to change the disk
status to ‘Failed’. The alarm will not alert you when this setting is changed. And any
potential warnings due to S.M.A.R.T attribute technology will not.
Changing HDD Temperature Threshold
To ensure hard disk temperatures remain within safe operating temperatures, enable
Storage Health Inspector to monitor disk temperatures. In SHI, you can set a threshold
so that the WebGUI or controller alarm (if enabled) can warn you when physical disks
get too hot.
1. Log in to WebGUI.
2. Select the controller from the drop down on the top left.
3. Click SHI.
4. Type the desired harddisk temperature threshold (°𝐹).
5. Click Set.
Utilizing the Health Inspector Scheduler
The Health Inspector Scheduler (HIS) enables you to periodically check your
disk/arrays to ensure they are functioning optimally.