HikRobot SC3000 Series - 17-Pin Interface Pins; MDI1+; DI_0; DI_1

SC3000 Series Vision Sensor Quick Start Guide
5
No.
Signal
I/O Signal Source
Description
Cable Color
15
MDI1+
--
Fast Ethernet signal MDI1+
Orange
16
DI_0
Line 0 signal line
Opto-isolated input
Gray
17
DI_1
Line 1 signal line
Opto-isolated input
White
Note
● You should refer to the table above and the label attached to the power and I/O cable to wire the
device.
● It is recommended to use the supplied 17-pin cable. The 6th, 7th, 14th, and 15th pin have been
made as RJ45 connector. The lines of other pins should be wired according to the actual demands.