HikRobot SC3000 Series - Output Wiring

SC3000 Series Vision Sensor Quick Start Guide
20
NPN Device
If you do not have available external resistors, you can wire the device as shown below.
Input Signal
PWR
Device Power
Ground
NPN
Device
NPN Device
Power
NPN Device
Power Ground
Signal Line
Device Power
GND
IN_COM
VCC
Figure 7-11 Configurable Input Signal Connects to NPN Device
7.2.2 Output Wiring
Note
● You can set I/O output type as PNP or NPN via the client software.
● If the external device is PNP, you should set the device’s output signal polarity as NPN.
● If the external device is NPN, you should set the device’s output signal polarity as PNP.
Output Signal
Line
Device Power
PWR
Device Power
Ground
External
Device
External Device
Power
External Device
Power Ground
Signal Line
VCC
GND
Figure 7-12 Output Wiring
Note
When the device's output signal is set as NPN, the voltage of VCC should not higher than that of
PWR. Otherwise, the device's output signal may have exception.
7.3 RS-232 Serial Port
The device can output data via the RS-232 serial port. You can go to the communication settings of