HikRobot SC3000 Series - Chapter 6: Client Layout and Operation Flow; Main Window Overview

SC3000 Series Vision Sensor Quick Start Guide
12
Chapter 6 Client Layout and Operation Flow
6.1 Main Window Introduction
After logging into the client software, you can see the main window as shown below.
Figure 6-1 Main Window
Note
● The specific interfaces of the client software may differ by its versions.
● The client software loads and runs previous projects after logging in. If there is no project, the
client software will create and run a new project.
Table 6-1 Main Window Description
No.
Name
Description
1
Menu Bar
The menu bar includes project, I/O settings, communication settings,
camera settings, and operation management.
2
Project Status
Display Area
This area displays operation results of current projects in real time. You
can run, stop or edit projects here.
3
Tool Status Display
Area
This area displays operation results of vision tools loaded in projects in real
time. You can edit various parameters of tools here.