27
3. Set the keypad name.
4. Check linked areas.
5. Select the keypad mode.
Standard Mode
Area selection and fault confirmation are supported when swiping tag to arm or disarm.
Simple Mode
No Area selection and fault confirmation when swiping tag to arm or disarm.
6. Enable the function according to your actual needs.
Authorization
Only standard mode has this function. You can select the authorization method.
Active on Entry Delay
When someone enters the delay zone, the screen and backlight of the keypad will be on.
This function can indicate the keypad position for those who enter the delay zone at night.
Keypad Arming Light
Enable the arming indicator of the keypad.
Note
Only enabled areas will be listed.
The newly added peripheral is linked to area 1 by default.
For detailed information, refers to the keypad user manual.
7. Click OK.
To Next Page
Loading...
Need help?
General
