48
6. Enable Periodic Test. Enter the periodic test interval.
7. Click Save.
Notification by Email
You can send the alarm video or event to the configured email.
Steps
1. Click Communication → Notification by Email to enter the page.
2. Enable Video Verification Events and Server Authentication.
3. Enter the sender’s information.
Note
It is recommended to use Gmail and Hotmail for sending mails.
Only if the zone is linked with a network camera, the alarm email will be attached with alarm
video.
4. Enter the receiver's information.
5. Click Receiver Address Test and make sure the address is correct.
6. Click Save.
NAT
Universal Plug and Play (UPnP™) is a networking architecture that provides compatibility among
networking equipment, software and other hardware devices. The UPnP protocol allows devices
to connect seamlessly and to simplify the implementation of networks in the home and corporate
environments.
Enable the UPnP function, and you don’t need to configure the port mapping for each port, and
the device is connected to the Wide Area Network via the router.
Steps
1. Click Communication → NAT to enter the page.
To Next Page
Loading...
Need help?
General
