93
Keypad Awake Time
If the keypad has no action within the set time, it will sleep automatically.
Active on Entry Delay
When enabled, the keypad can be used during the entry delay.
Chime Indication
Enable chime.
Area Status
Display area status and alarm information in the keypad main page.
Remote Arm/Disarm Indication
Enable the remote arm/disarm LED indication.
Polling Rate
Sets the interval at which the system requires the device to return a report. If the device
takes longer than the Polling failure Times to determine offline to reply, the system will
report faults and the status of device will be shown as offline.
Backlight
Enable the keypad backlight. You can configure the time schedule when the backlight is off.
Alarm Buzzer/Button Buzzer
Enable the alarm buzzer/button buzzer.
Silent Panic Alarm/Silent Medical Alarm
Panic alarm/Medical alarm do not sound.
Text1/Text2
The text displayed on the main page when waking up. Customizable content.
4. Click Save.
Tag Reader
You can set the parameters of the tag reader.
Steps
1. Click Device Management → Mount Device → Tag Reader to enter the page.
2. Click +Add to add a tag reader.
3. Click to edit the tag reader parameters.
To Next Page
Loading...
Need help?
General
