HD-TVI Speed Dome·Quick Start Guide
Baudrate Settings
The No. 1, 2 of SW2 switches are for setting the baudrate of the speed dome, standing for 2400bps,
4800bps, 9600bps and 19200bps respectively. The baudrate will be set as 2400bps by default if it is
out of this range. Refer to the following table:
Table 1-13 Set the Baudrate of the Dome
DIP Switch SW2-Baudrate Settings
Protocol Settings
For convenient settings, refer to the following list to set the protocol for the speed dome.
Table 1-14 Set the Protocol of the Dome
DIP Switch SW2-Protocol Settings
TVI Mode Settings
The No. 7 of SW2 switches is for setting the TVI mode of the speed dome. You can refer to the
following table for details of setting the speed dome TVI mode.
Table 1-15 Set the TVI Mode