Network Camera User Manual
143
please refer to the Task 1: Set the Motion Detection Area in the Section
10.1.1.
Record Triggered by Alarm
If you select Alarm, the video will be recorded when the alarm is triggered
via the external alarm input channels.
Besides configuring the recording schedule, you have to set the Alarm Type
and check the checkbox of Trigger Channel in the Linkage Method of
Alarm Input Settings interface. For detailed information, please refer to
Section 10.1.3.
Record Triggered by Motion & Alarm
If you select Motion & Alarm, the video will be recorded when the motion
and alarm are triggered at the same time.
Besides configuring the recording schedule, you have to configure the settings
on the Motion Detection and Alarm Input Settings interfaces. Please refer to
Section 10.1.1.and Section 10.1.3 for detailed information.
Record Triggered by Motion | Alarm
If you select Motion | Alarm, the video will be recorded when the external
alarm is triggered or the motion is detected.
Besides configuring the recording schedule, you have to configure the settings
on the Motion Detection and Alarm Input Settings interfaces. Please refer to
Section 10.1.1.and Section 10.1.3 for detailed information.
Record Triggered by Events
If you select Event, the video will be recorded if any of the events is triggered.
Besides configuring the recording schedule, you have to configure the event
settings.
5. Select the record type, and click-and-drag the mouse on the time bar to set the
record schedule.
6. Click Save to save the settings.
To Next Page
Loading...
