Network Camera User Manual
34
Online Upgrade
For some camera models, when memory card is mounted, you can click the Update
button that appears on the right of Firmware Version text field to see if there is a new
version available. If a new version is available, the version number will be displayed
in the New Version text field below, and you can click the Upgrade button to upgrade
the firmware for the camera.
Figure 6-3 Online Upgrade
Note: When the camera is upgrading, don't power off the camera. During upgrading,
the camera may not be accessible. You need to wait 1 or 2 minutes before the upgrade
finishes.
6.2.2 Configuring Time Settings
Purpose:
You can follow the instructions in this section to configure the time synchronization
and DST settings.
Steps:
1. Enter the Time Settings interface, Configuration > System> System Settings >
Time Settings.
To Next Page
Loading...
