Network Camera User Manual
134
Advanced Configuration
Detection Parameters:
Generation Speed [1 to 5]: The speed to identify a target. The higher the value, the
faster the target will be recognized. Setting the value quite low, and if there was a face
in the configured area from the start, this face will not be captured. It can reduce the
misinformation of the faces in the wall painting or posters. The default value of 3 is
recommended.
Sensitivity [1 to 5]: The sensitivity to identify a target. The higher the value is, the
easier a face will be recognized, and the higher possibility of misinformation would be.
The default value of 3 is recommended.
Capture Parameters:
Face Capture Mode: Best Shot and Quick Shot are available.
Best Shot: The best shot after target leave the detection area.
Capture Times [1 to 3]: Refers to the capture times a face will be captured
during its stay in the configured area.
Capture Interval: [1 to 255 Frame]: The frame interval to capture a picture. If
you set the value as 1, which is the default value, it means the camera
captures the face in every frame.
Capture Threshold: It stands for the quality of face to trigger capture and
alarm. Higher value means better quality should be met to trigger capture
and alarm.
To Next Page
Loading...
Need help?
General
