Network Camera User Manual
135
Quick Shot: You can define quick shot threshold and max. capture interval.
Quick Shot Threshold: It stands for the quality of face to trigger quick shot.
Capture Times: It can be set as limited and unlimited. When it is set as
limited, it can be set [0 to 100]. Refers to the capture times a face will be
captured during its stay in the configured area.
Face Exposure: Check the checkbox to enable the face exposure.
Reference Brightness [0 to 100]: The reference brightness of a face in the face
exposure mode. If a face is detected, the camera adjusts the face brightness according
to the value you set. The higher the value, the brighter the face is.
Minimum Duration [1 to 60 minute(s)]: The minimum duration of the camera
exposures the face.
Note: If the face exposure is enabled, please make sure the WDR function is disabled,
and the manual iris is selected.
Face Filtering Time: It means the time interval between the camera detecting a face
and taking a capture action. If the detected face stays in the scene for less than the set
filtering time, capture will not be triggered. For example, if the face filtering time is set
as 5 seconds, the camera will capture the detected face when the face keeps staying
in the scene for 5 seconds.
Note: The face filtering time (longer than 0 s) may increase the possibility of the actual
capture times less than the set value above.
Invalid Capture Filter: Check the checkbox to enable invalid capture filter. The invalid
captured face pictures will be filtered if the function is enabled.
Restore Default: Click Restore to restore all the settings in advanced configuration to
the factory default.
To Next Page
Loading...
Need help?
General
