Network Camera User Manual
21
depending on different routers. Please call the router manufacturer for assistance
with port mapping.
Note: Refer to Appendix 2 Port Mapping for detailed information about port mapping.
5. Apply a domain name from a domain name provider.
6. Configure the DDNS settings in the setting interface of the router.
7. Visit the camera via the applied domain name.
Connecting the network camera via a modem
Purpose:
This camera supports the PPPoE auto dial-up function. The camera gets a public IP
address by ADSL dial-up after the camera is connected to a modem. You need to
configure the PPPoE parameters of the network camera. Refer to 7.1.3 Configuring
PPPoE Settings for detailed configuration.
Accessing the Camera with Dynamic IP
Note: The obtained IP address is dynamically assigned via PPPoE, so the IP address
always changes after rebooting the camera. To solve the inconvenience of the dynamic
IP, you need to get a domain name from the DDNS provider (E.g. DynDns.com). Please
follow the steps below for normal domain name resolution and private domain name
resolution to solve the problem.
Normal Domain Name Resolution
Normal Domain Name Resolution
To Next Page
Loading...
Need help?
General
