Network Camera User Manual
78
4) (Optional) You can click Send Test SMS to send a message to the mobile
phone for test.
5) Click Save to save the settings.
HTTPS Settings
Purpose:
HTTPS provides authentication of the web site and its associated web server, which
protects against Man-in-the-middle attacks. Perform the following steps to set the port
number of https.
E.g., If you set the port number as 443 and the IP address is 192.168.1.64, you may
access the device by inputting https://192.168.1.64:443 via the web browser.
Note:
If you use HTTPS to visit the camera, you should enable WebSockets for live
view. Go to Configuration > Network > Advanced Settings > Network
Service.
For some camera models, HTTPS is enabled by default. The camera creates an
unsigned certificate automatically. When you visit the camera via HTTPS, the
web browser will send a notification about the certificate issue. Install a
signed-certificate to the camera to cancel the notification.
Steps:
1. Enter the HTTPS settings interface. Configuration > Network > Advanced
Settings > HTTPS.
2. Check the checkbox of Enable to enable the function.
To Next Page
Loading...
Need help?
General
