User Manual of Digital Video Recorder
161
enabled, it only allows the remote user with this MAC address to access the DVR.
4. Click the OK button to save the settings and go back to the User Management interface. The added new user
will be displayed on the list, as shown in Figure 13. 6.
Figure 13. 6 Added User Listed in User Management Interface
5. Select the user from the list and then click the button to enter the Permission settings interface, as
shown in Figure 13. 7.
Figure 13. 7 User Permission Settings Interface
6. Set the operating permission of Local Configuration, Remote Configuration and Camera Configuration for
the user.
Local Configuration
• Local Log Search: Searching and viewing logs and system information of DVR.
• Local Parameters Settings: Configuring parameters, restoring factory default parameters and
importing/exporting configuration files.
• Local Advanced Operation: Operating HDD management (initializing HDD, setting HDD property),
upgrading system firmware, clearing I/O alarm output.
• Local Shutdown Reboot: Shutting down or rebooting the DVR.
Remote Configuration
• Remote Log Search: Remotely viewing logs that are saved on the DVR.
• Remote Parameters Settings: Remotely configuring parameters, restoring factory default parameters and
importing/exporting configuration files.
• Remote Serial Port Control: Configuring settings for RS-232 and RS-485 ports.
• Remote Video Output Control: Sending remote button control signal.
• Two-way Audio: Realizing two-way radio between the remote client and the DVR.
• Remote Alarm Control: Remotely arming (notify alarm and exception message to the remote client) and
controlling the alarm output.
• Remote Advanced Operation: Remotely operating HDD management (initializing HDD, setting HDD
To Next Page
Loading...
Need help?
General
Weight and Dimensions
