Figure 1-21 Install the Speed Dome
4) Loosen the two lock screws on the bracket.
5) Install the speed dome to the bracket. Rotate the speed dome clockwise tightly.
6) Secure the two lock screws with the Allen wrench as shown in Figure 1-22.
Figure 1-22 Secure the Speed Dome
5. Remove the protective film of the IR or laser light after you finish installing.
The bracket in Figure 1-13 is the recommended bracket for this series of speed dome, and a
pendent adapter is required if any other bracket is selected. See Figure 1-23.
The dimension of pendant adapter is G1
1
2
.
To Next Page
Loading...
