Network Speed Dome User Manual
Configuring FTP Settings for setting FTP parameters.
Trigger Channel
Record a video when an event occurs.
You have to set the recording schedule to realize this function. Please refer
to Section 5.1 Storage Settings for settings the recording schedule.
Trigger Alarm Output
Trigger one or more external alarm outputs when an event occurs.
To trigger an alarm output when an event occurs, please refer to Section
5.2.5 Configuring Alarm Output to set the alarm output parameters.
5.2.2 Configuring Video Loss Alarm
Steps:
1. Enter the Video Loss Setting interface:
Configuration > Event > Basic Event > Video Loss
Figure 5-17 Video Loss
2. Check the Enable checkbox to enable the video loss detection.
3. Click tab to enter the arming schedule setting interface. The
arming schedule configuration is the same as the setting of the arming schedule
for motion detection. Refer to Step 2 in Section 5.2.1 Configuring Motion
Detection.
To Next Page
Loading...
Need help?
General
