© Hikvision
You can enable the Hik-Connect service for the device during activation. Hik-Connect function
varies depending on different speed dome models.
4. Click Activate to start activation. You can check whether the activation is completed on the
popup window. If activation failed, make sure that the password meets the requirement and
then try again.
5. Change the device IP address to the same subnet with your computer by either modifying
the IP address manually or checking the Enable DHCP checkbox.
Figure 2-5 Modify the IP Address
6. Input the password and click Modify to activate your IP address modification.
The batch IP address modification is supported by the SADP. Refer to the user manual of
SADP for details.
Activation via Client Software
The client software is versatile video management software for multiple kinds of devices.
Get the client software from the supplied disk or the official website, and install the software
according to the prompts. Follow the steps to activate the camera.
Steps:
1. Run the client software and the control panel of the software pops up, as shown in Figure
2-6.
To Next Page
Loading...
Need help?
General
