© Hikvision
2. Check the checkbox to enable the UPnP™ function.
Note:
You can edit the Friendly Name of the camera. This name can be detected by corresponding
device, such as a router.
3. Set the port mapping mode:
To port mapping with the default port numbers:
Choose
To port mapping with the customized port numbers:
Choose
And you can customize the value of the port number by yourself.
Figure 6-6 Port Mapping Mode
4. Click to save the settings.
Configuring Multicast
Purpose:
Multicast is group communication where data transmission is addressed to a group of destination
devices simultaneously. After setting up active multicast, you can send the source efficiently to
multiple devices.
Figure 6-7 Setting Multicast
Steps:
1. Enter the Multicast setting interface.
Configuration >Network > Basic Settings > Multicast
To Next Page
Loading...
Need help?
General
