User Manual of PanoVu Series Network Camera
Figure 2-11 Child Directory
Upload type: To enable uploading the captured picture to the FTP server.
3. Click to save the settings.
Note:
If you want to upload the captured pictures to FTP server, you also have to enable the continuous
snapshot or event-triggered snapshot in Snapshot interface. For detailed information, refer to the
Section 5.1.4 Configuring Capture Schedule.
Configuring Email Settings
Purpose:
The system can be configured to send an Email notification to all designated receivers if an alarm event
is detected, e.g., motion detection event, video loss, video tampering, etc.
Before you start:
Configure the DNS Server settings under Configuration > Network > Basic Settings > TCP/IP before using
the Email function.
Steps:
1. Enter the Email settings interface:
Configuration> Network > Advanced Settings > Email
Figure 2-12 Email Settings
2. Configure the following settings:
Sender: The name of the email sender.
Sender’s Address: The email address of the sender.
SMTP Server: The SMTP Server IP address or host name (e.g., smtp.263xmail.com).
To Next Page
Loading...
Need help?
General
