DS-3E1xxxP Series 100 Mbps PoE Switches Quick Start Guide
QSG DS-3E1xxxP Switch 012721NA 8
Rear Panel
Figure 1-3 DS-3E1X05/09P Series
Figure 1-4 DS-3E1318/26P Series
Port/Indicator Description
PoE-MAX Indicator
•
Solid /Flashing: The output power of the switch will reach the upper limit. The
power supply may be abnormal if more devices are connected.
• Unlit: The switch provides power supply to PD normally
PWR Indicator
•
Solid: The switch is powered on normally
• Unlit: No power supply connected or power supply is abnormal
LINK/ACT Indicator
•
Solid: The port is connected
• Flashing: The port is transmitting data
•
Unlit: The port is disconnected or connection is abnormal
PoE Indicator
•
Solid: The switch provides power supply to PD normally
• Unlit: The switch is disconnected to PD or provides power supply to PD
G1/G2 Port Indicator
• Solid: The gigabit SFP fiber optical port is connected
• Flashing: The gigabit SFP fiber optical port is transmitting data
• Unlit: No gigabit SFP fiber optical port connected or connection is abnormal
100 Mbps PoE RJ-45 Port
• Used for PD devices connection via network cables
100 Mbps RJ-45 Port • Used for other devices connection via network cables
Gigabit Combo
•
When connected to a network cable, the combo is an RJ-45 port. When
plugged into an optical module and connected to an optical fiber, the combo
functions as a fiber optic port.
• When connected to both the network cable and optical fiber at the same
time, the port works as a fiber optic port.
Grounding Terminal • Used to connect to the grounding cable to protect the switch from lightning
Power Supply • Use the attached power cord to connect the switch to socket
To Next Page
Loading...
