Need help?Do you have a question about the HIKVISION DS-3E15 P Series and is the answer not in the manual?
General| Product Series | P Series |
|---|---|
| Switch Type | Unmanaged |
| Jumbo Frame Support | 9 KB |
| Operating Humidity | 10% to 90% (non-condensing) |
| Model | DS-3E15 |
| Packet Forwarding Rate | 7.44 Mpps |
| MAC Address Table | 8K |
| Power Supply | AC 100-240V, 50/60Hz |
| Power Consumption | Max 15W |
| Operating Temperature | 0°C to 40°C |
| Storage Temperature | -40°C to 70°C |
| Storage Humidity | 5% to 95% (non-condensing) |
| Dimensions | 440mm x 180mm x 44mm |
| Installation | Desktop |
Process to create a password and activate inactive devices before adding them to the software.
Steps to add detected online devices to the client software, including entering device information.
View device usage, device panel status, and port information for monitoring purposes.
Check the bitrate, duplex, and flow control of network ports.
View sent/received bytes, packets, rates, and peak values for network ports.
Check the enabling status and output power of different PoE ports.
Navigate and interact with the network topology display interface for visualization and analysis.
Configure display level and bandwidth alarm thresholds for the network typology visualization.
Configure NIC type, IPv4 address, subnet mask, default gateway, and ports.
Configure bitrate, duplex, flow control, and enable/disable port links.
Enable or disable PoE power supply for connected powered devices (PDs).
Configure load balancing mode for aggregated links, typically based on MAC addresses.
Create aggregation groups by adding ports, up to 4 ports per group.
View device details like name, model, serial number, and port information.
Manage the single admin user, including editing passwords, IP addresses, and permissions.
Perform device maintenance tasks like rebooting, restoring defaults, and upgrading firmware.
Search, view, and export system operation logs for backup and analysis.
Unlock locked IPs caused by failed login attempts via the security interface.
To Next Page