EasyManua.ls Logo

HIKVISION DS-3E1326P-EI

HIKVISION DS-3E1326P-EI
15 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
DS-3E1xxxP Series
100 Mbps PoE Switches
Quick Start Guide
Question and Answer IconNeed help?

Do you have a question about the HIKVISION DS-3E1326P-EI and is the answer not in the manual?

HIKVISION DS-3E1326P-EI Specifications

General IconGeneral
Switch type-
Product colorBlue
Housing materialMetal
Combo SFP ports quantity2
Installed SFP modules quantity0
Basic switching RJ-45 Ethernet ports typeFast Ethernet (10/100)
Basic switching RJ-45 Ethernet ports quantity24
10G supportNo
Full duplexYes
Networking standardsIEEE 802.3, IEEE 802.3ab, IEEE 802.3af, IEEE 802.3at, IEEE 802.3u, IEEE 802.3x, IEEE 802.3z
Forwarding rate6.5472 Mpps
MAC address table16000 entries
Input current6.5 A
AC input voltage100 - 240 V
AC input frequency50 - 60 Hz
Power consumption (max)400 W
Total Power over Ethernet (PoE) budget370 W
Power over Ethernet (PoE) power per port30 W
Storage temperature (T-T)-40 - 85 °C
Operating temperature (T-T)-10 - 55 °C
Operating relative humidity (H-H)5 - 95 %
Weight and Dimensions IconWeight and Dimensions
Depth221 mm
Width440 mm
Height44 mm
Weight2830 g

Summary

Legal Information

Regulatory Information

Preface

Applicable Models

Specifies the switch models covered by this manual.

Symbol Conventions

Defines symbols used in the document for warnings and notes.

Safety Instruction

Provides critical safety instructions and warnings for using the device.

Cautions

Lists important cautions and warnings related to device operation and environment.

Introduction

Product Introduction

Provides an overview of the DS-3E1xxxP Series switches and their capabilities.

Packing List

Lists all items included in the product package for different series.

Appearance

Describes the physical appearance of the front panel for different device models.

Port and Indicator Descriptions

Installation

Desk-Mounted Installation

Instructions for placing the device on a desk for setup.

Wall-Mounted Installation

Step-by-step guide for mounting the device on a wall using screws.

Rack-Mounted Installation

Guide for installing the switch into a standard equipment rack.

Grounding

Connecting the Grounding Cable

Explains how to connect the grounding cable for lightning protection.

Grounding with Grounding Bar

Specific steps for grounding the device when a grounding bar is available.

Grounding without Grounding Bar

Steps for grounding the device using an angle steel or steel pipe.

Connecting RJ-45 Port

Instructions for connecting network devices using RJ-45 ports.

Connecting SFP Optical Module

Guide for installing and connecting SFP optical modules for fiber optic links.

Powering on the Device

Device Management

Activating Devices

Process for activating inactive devices before management via software.

Adding Devices

Guide on how to add detected online devices to the management software.

Get More Information

Related product manuals