Chapter 2 Installation
2.1 Cautions
Similar to other electronic products, the semiconductor chip easily gets damaged if you power on and
off abruptly and frequently. To restart up the switch of DS-3T3512P, you have to open the power
on-off three or five seconds after the power is cut off.
Avoid severe collision or falling down from the height to protect the parts in the switch.
Use correct outside ports to connect the switch of DS-3T3512P. Do not insert the Ethernet plug into
the console port (RJ45 8-line socket). Similarly, do not insert the console cable into the console port
(RJ45 8-line socket).
Note:
1) When you plug or dial out the power line, keep the power line horizontal with the power socket.
2) When the lifetime of our products ends, handle them according to national laws and regulations,
or send these products to our company for collective processing.
3) When using the product, please use the chassis that meets the fire protection requirements
2.2 Safety Advice
2.2.1 Safety Principles
Keep dustless and clean during or after the installation.
Put the cover at the safe place.
Put tools at the right place where they are not easily falling down.
Put on relatively tight clothes, fasten the tie or scarf well and roll up
the sleeve, avoiding stumbling the chassis.
Put on the protective glasses if the environment may cause damage
to your eyes.
Avoid incorrect operations that may cause damage to human or
devices.
2.2.2 Safety Notices
The safety notices mentioned here means that improper operation may lead to body damage.
Read the installation guide carefully before you operate the system.
Only professionals are allowed to install or replace the switch.
To Next Page
Loading...
Need help?
General