Network Video Recorder User Manual
26
Sort Channel Order
Channel layout windows are ordered by channel number. You can change the camera linked
channel number by dragging windows.
Steps
1. Go to Configuration → Camera → Camera.
2. Click Sort Channel.
3. Drag a channel window to the channel number as your desire.
4. Click Apply.
Note
After sorting channels, the device will reconnect to network cameras.
Configure Remote Settings
For the camera parameters that were only configurable via web browser, remote settings function
provides an operation interface to configure remote camera parameters.
Before You Start
Ensure your camera is properly connected.
Steps
1. Go to Configuration → Camera → IP Camera.
2. Click Remote Settings
3. After the device resource is initialized, select a camera.
4. Set camera parameters.
Upgrade Network Camera
The Network camera can be remotely upgraded through the device.
Before You Start
● Ensure you have inserted the USB flash drive to the device, and it contains the network camera
upgrade firmware.
● Ensure your network camera is on the same network segment with your video recorder.
● Ensure the network connection is valid and correct.
Steps
1. Go to Configuration → Camera → IP Camera.
2. Click .
3. Click Yes to confirm.
4. Select the camera upgrade firmware from your storage device.
5. Click Upgrade to start upgrading. The camera will restarted automatically after upgrade
completed.
To Next Page
Loading...
Need help?
General
