Network Video Recorder User Manual
63
3) Optional: Set Target Detection as Human or Vehicle to discard alarms which are not
triggered by human body or vehicle.
4) Click Draw Area and draw a quadrilateral in the preview window by specifying four vertexes
of the detection region.
7. Set the arming schedule. Refer to Configure Arming Schedule for details.
8. Set the linkage actions. Refer to Configure Alarm Linkage Action for details.
9. Click Apply.
Region Entrance Detection
Region entrance detection function detects people, vehicles or other objects which enter a pre-
defined virtual region from the outside place, and some certain actions can be taken when the
alarm is triggered.
Steps
1. Go to Configuration → Event → Smart Event → Region Entrance.
Figure 6-25 Region Entrance Detection
2. Set Camera.
3. Select VCA Mode.
By NVR
The event will be analyzed by NVR. The device can analyze videos that contain human and
vehicle. Only the target of selected type (human or vehicle) will trigger alarms, which can
reduce false alarms that are caused by other objects.
By Camera
To Next Page
Loading...
Need help?
General
