Network Video Recorder User Manual
128
Set Motion Detection
Select the camera to configure the motion detection.
Check Enable.
Set the motion detection area.
Full screen: click to set the full-screen motion detection for the image.
Customized area: use the mouse to click and drag on the preview screen to draw
the customized motion detection area (s).
You can click Clear to clear the current motion detection area settings and draw again.
Set sensitivity (0-100). The sensitivity allows you to calibrate how readily movement
triggers the alarm. The higher value results in the more readily to trigger the motion
detection.
Set the arming schedule. Refer to Chapter 11.1 Configure Arming Schedule.
Set the linkage actions. Refer to Chapter 11.2 Configure Alarm Linkage Actions.
To Next Page
Loading...
Need help?
General