Need help?Do you have a question about the HIKVISION DS-9000HFI-ST and is the answer not in the manual?
Step-by-step guide for initial device setup using the configuration wizard.
Instructions for adding and configuring IP cameras to the HDVR system.
Setting up parameters for PTZ camera control, such as baud rate and protocol.
Configuring predefined camera positions, automated patrol paths, and movement patterns.
Defining video quality, resolution, bitrate, and other parameters for recording.
Setting up schedules for automatic recording and capturing based on time or events.
Setting up motion detection parameters to trigger recording or capture.
Configuring alarm inputs to trigger recording or capture actions.
Methods for searching and playing back recorded video files by channel, time, or event.
Procedures for exporting recorded video files to backup devices.
Methods for backing up captured still images from the device.
Configuring motion detection parameters to trigger alarms and recording.
Setting up external sensor alarms and their corresponding actions.
Configuring Video Content Analysis (VCA) alarms for smart IP cameras.
Setting up alarms and actions for detecting video signal loss.
Configuring alarms and actions for detecting video tampering, like lens cover.
Defining actions to be triggered when an alarm or exception occurs.
Basic network configuration including IP address, subnet mask, and working modes.
Advanced network configurations like PPPoE, DDNS, NTP, FTP, SNMP, NAT, and HTTPS.
Creating RAID arrays and virtual disks for data storage and redundancy.
Procedures for automatically or manually rebuilding RAID arrays after disk failure.
Process for initializing newly installed hard disk drives before use.
Guidance for resolving common issues and problems with the device.
To Next Page
General