User Manual of Digital Video Recorder
197
In this chapter, we use the interface of DS-9100HFI-ST series (unless otherwise stated) as example to describe the
following settings.
11.1 Initializing HDDs
Purpose:
A newly installed hard disk drive (HDD) must be initialized before it can be used with your device.
If there is uninitialized HDD existed in the device, the following message box pops up when the device starts up.
Figure 11. 1 Message Box of Uninitialized HDD
Click Yes to initialize it immediately or you can perform the following steps to initialize the HDD(s).
Steps:
1. Enter the HDD Information interface.
Menu > HDD > General
Figure 11. 2 HDD Information Interface
2. Select HDD to be initialized.
3. Click Init.
To Next Page
Loading...
Need help?
General