Quick Operation Guide of Network Video Recorder
13
Basic Operation
Power On
If the power LED indicator on the front panel is off, please check whether the power supply is plugged into an
electrical outlet and the power switch on the rear panel is turned on; the LED turns red, indicating the device is
receiving power.
When the LED is red, please press the Power button on the front panel. The Power indicator will turn blue. The
device will begin to start.
It is highly recommended that an Uninterruptible Power Supply (UPS) be used in conjunction with the
device.
When the Ready indicator turns blue, the device is powered on and works properly.
Power Off
Standard Shutdown
Press and hold the POWER button for 3 seconds; the device will enter power off process, when power indicator
turns red, turn off the power switch on the rear panel.
Other Methods of Shutdown
• Shutdown with Power Switch
Please try to avoid shutting down the device by turning off the power switch on the rear panel (especially
during recording).
• Shutdown by Unplugging Power Supply
Please try to avoid shutting down the device by unplugging power supply (especially during recording).
Login and Exit
Accessing the Device by Client Software
Steps:
1. Click “Start””All Programs”“iVMS-4200 Station”“VMS Software”“iVMS-4200 Client” to start
the client software.
2. Enter the Device Management interface and click Add Device button to pop up the detail information editing
dialog box. Edit the Nickname, Address, Port, User Name and Password, and then click the Add button to
add it.
To Next Page
Loading...
Need help?
General
