HIKVISION DS-9508NIST User Manual

Quick Operation Guide of Network Video Recorder
2
Thank you for purchasing our product. If there is any question or request, please do not hesitate to contact dealer.
This manual is applicable to the models listed in the following table.
Series
Model
Type
9500NI-ST
DS-9508NI-ST
DS-9516NI-ST
DS-9532NI-ST
DS-9564NI-ST
Network Video Recorder
9500NI-RT
DS-9508NI-RT
DS-9516NI-RT
DS-9532NI-RT
DS-9564NI-RT
Network Video Recorder
8500NI-ST
DS-8508NI-ST
DS-8516NI-ST
DS-8532NI-ST
DS-8564NI-ST
Network Video Recorder
NVR Pre-Installation
The DS-9500/8500NI-ST and DS-9500NI-RT Series NVR is highly advanced surveillance equipment that should
be installed with care. Please take into consideration the following precautionary steps before installation of the
NVR.
1. Keep all liquids away from the NVR.
2. Install the NVR in a well-ventilated and dust-free area.
3. Ensure environmental conditions meet factory specifications.
4. Install a manufacturer recommended HDD.
NVR Installation
During the installation of the NVR:
1. Use brackets for rack mounting.
2. Ensure there is ample room for audio and video cables.
3. When routing cables, ensure that the bend radius of the cables are no less than five times than its diameter.
4. Connect both the alarm and RS-485 cable.
5. Allow at least 2cm (≈0.75in) of space between racks mounted devices.
6. Ensure the NVR is grounded.
7. Environmental temperature should be within the range of -10 ºC ~ 55 ºC , 14ºF ~ 131ºF.
8. Environmental humidity should be within the range of 10% ~ 90%.
Hard Disk Installation
Disconnect the power from the NVR before installing a hard disk drive (HDD). A factory recommended HDD
should be used for this installation.
Tools Required: Screwdriver.
Steps (for DS-9500NI-ST/RT):
1. Fasten the hard disk mounting handle to the hard disk with screws.

HIKVISION DS-9508NIST Specifications

General

Brand	HIKVISION
Model	DS-9508NIST
Category	Network Hardware
Language	English