Quick Operation Guide of Network Video Recorder
20
When IP camera is connected to the NVR, the all-day continuous recording of it starts automatically.
3. Click Edit button to enter setup page.
4. Select recording type in the drop-down list.
There are six recording types supported, including “Continuous”, “Motion Detection”, “Alarm”, “Motion
detection & Alarm”, “Motion detection | Alarm” and “VCA”.
“&” means recording is triggered when both the two events happened at the same time.
“|” means recording is triggered when either the event happened.
To realize recording triggered by event (the types mentioned above except “Continuous”), you need to
configure the alarm or motion settings first. Please refer to the User Manual for details.
5. Select one day in a week, and select All Day recording as you need. You may also set period recording
by disable All Day recording; there are 8 time periods in one day. Then you can select schedule
recording from the drop-down menu. Then you can also copy the settings to whole week or to any day
of the week.
Please make sure that each time period is not overlapped.
6. Click the Advanced button to set advanced parameters.
You can configure parameters of enable ANR (Automatic Network Replenishment), Pre-record time,
Post-record time, Stream Type, Record Audio and Expired Time.
To Next Page
Loading...
