Network Video Recorder User Manual
26
Note
If exception occurs, error information will be displayed on the screen. Click to edit the
parameters of different channel(s).
3.1.1 Configure Live View Settings
Live View settings can be customized. You can configure the output interface, dwell time for
screen to be shown, mute or turning on the audio, the screen number for each channel, etc.
Steps
1. Go to System → Live View → General.
Figure 3-2 Live View-General
2. Configure the live view parameters.
Video Output Interface
Select the video output to configure.
Live View Mode
Select the display mode for Live View, e.g., 2*2, 1*5, etc.
Dwell Time
The time in seconds to wait between switching of cameras when using auto-switch in Live
View.
Enable Audio Output
Enable/disable audio output for the selected video output.
Volume
Adjust the Live View volume, playback and two-way audio for the selected output interface.
Event Output
Select the output to show event video.
Full Screen Monitoring Dwell Time
To Next Page
Loading...
