DS-K1100 Series Card Readers Connect
to DS-K1T105&DS-K1T200 Series
Access Control Terminal
DS-K1100 Series Card Readers Connect to
DS-K1T105&DS-K1T200 Series Access Control Terminal
Preparation
Connecting card reader to access control terminal is mainly applied to swiping card to open the door for
exiting. For card reader, access controller and access control terminal in this documents, please check the
table below:
DS-K1101M/MK, DS-K1102M/MK,
DS-K1103M/MK, DS-K1104M/MK,
DS-K1107M/MK, DS-K1108M/MK
DS-K1T105M/M-C
DS-K1T200MF/MF-C
DS-K1102E/EK, DS-K1107E/EK,
DS-K1108E/EK
DS-K1T105E/E-C
DS-K1T200EF/EF-C
Note
If the model of access control terminal is DS-K1T105E/E-C or DS-K1T200EF/EF-C, we suggest
customers should match the following several card readers, such as DS-K1102E/EK, DS-K1107E/EK and
DS-K1108E/EK; you can find the same symbol ‘E’ in the access control terminal and card reader model
name, that means both devices can recognize the EM Card.
The ‘M’ access control terminal should be matched the ‘M’ card reader either, and they can recognize the
Mifare1 Card.
Notice
1. Please cut off power supply before wiring;
2. DS-K1100 Series Card Readers support private RS485 protocol and standard Wiegand protocol ,
correspondingly, there are RS485 interfaces and Wiegand interfaces in access control terminal, so
there are two optional ways of wiring;
To Next Page
Need help?
General
Weight and Dimensions
