HIKVISION DS-K1201A Series User Manual

DS-K1201 Fingerprint Card Reader
2
Chapter 2 Installation
2.1 Introduction for DIP Switch
The DIP switch module is shown below. The No. of DIP switch from left to right is 1
to 4, representing the RS-485 address.
Figure 2-1 DIP Switch Module
Table 1-2 Description of DIP Switch
Icon
Description
1
Represent ON in binary mode
0
Represent OFF in binary mode
For example, the binary value of the following status is 1100.
Figure 2-2 DIP Switch Module
Note: The DIP switch of RS-485 address should reach the access control devices
requirements. For different access control devices, the DIP switch addresses may be
different.
2.2 Definition of Cable
The description of 5 cables is shown below.
Table 1-3 Description of Cables
Color
Description
Blue
RS-485 -
Yellow
RS-485 +
Red
PWR (DC +12V)
Black
GND (Power Grounding)
Black
GND (RS-485 Grounding)

HIKVISION DS-K1201A Series Specifications

General

Model	DS-K1201A Series
Type	Card Reader
Power Supply	12 VDC
Card Reading Frequency	13.56 MHz
Wiegand Interface	Wiegand 26/34
Power Consumption	≤ 3 W
Protection Level	IP65
Working Humidity	10% to 90% (non-condensing)
Material	ABS
Operating Current	≤ 250 mA
Communication Interface	RS-485
Card Type	Mifare, EM
Operating Temperature	-20° C to +65° C (-4° F to +149° F)
Operating System	Linux