EasyManuals Logo

HIKVISION DS-K1T341CMFW User Manual

HIKVISION DS-K1T341CMFW
218 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #158 background imageLoading...
Page #158 background image
Note
If you select the enrollment staon, you should click Login to set related parameters of the
device including IP address, port No., user name, and password. Also, you can check Face An-
Spoong and select the liveness level as Low, Medium, or High.
Face An-Spoong
If you check this funcon, then the device can detect whether the face to be collected is an
authenc one.
6.
Collect face.
1) Face to the camera of the selected access control device and make sure your face is in the
middle of the
collecng window.
2) Click to capture a photo.
3) Click OK to save the captured photo.
7.
Conrm to add the person.
-
Click Add to add the person and close the Add Person window.
-
Click Add and New to add the person and
connue to add other persons .
9.4.7 Collect Fingerprint via Client
Collecng ngerprints locally means you can collect the ngerprint via the ngerprint recorder
connected directly to the PC running the client. The
ngerprints recorded can be used as
credenals of the persons to access the authorized doors.
Before You Start
Connect the ngerprint recorder to the PC running the client.
Steps
1.
Enter Person module.
2.
Select an
organizaon in the organizaon list to add the person and click Add.
Note
Enter the person's basic informaon rst. For details about conguring person's basic
informaon, refer to Congure Basic Informaon .
3.
In the Credenal → Fingerprint panel, click +.
4.
In the pop-up window, select the
collecon mode as Local.
5.
Select the model of the connected ngerprint recorder.
Note
If the ngerprint recorder is DS-K1F800-F, you can click Sengs to select the COM the
ngerprint recorder connects to.
6.
Collect the ngerprint.
1) Click Start.
2) Place and
li your ngerprint on the ngerprint recorder to collect the ngerprint.
DS-K1T341C Series Face Recognion Terminal User Manual
142

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the HIKVISION DS-K1T341CMFW and is the answer not in the manual?

HIKVISION DS-K1T341CMFW Specifications

General IconGeneral
TypeFace recognition terminal
Face capacity3000
Product colorBlack, Grey
Cards capacity3000 cards
Event capacity150000
Wiegand interfaceYes
Fingerprint reader-
Authentication typeAccess chip/card, Face recognition
Fingerprint sensor typeOptical
Face recognition accuracy99 %
Face recognition distance1 - 2 m
Face recognition duration0.2 s
Access chip/card reader typeContactless
International Protection (IP) codeIP65
Display typeLCD
Screen shapeFlat
Display diagonal4.3 \
Maximum resolution272 x 480 pixels
Touchscreen technologyCapacitive
Sensor typeCMOS
Total megapixels2 MP
Front camera typeDual camera
Operating system installedLinux
Ethernet LAN data rates10, 100 Mbit/s
Input current2 A
Input voltage12 - 24 V
Power consumption (typical)10 W
Operating temperature (T-T)-30 - 60 °C

Related product manuals