HIKVISION DS-K1T341CMFW User Manual

Note
●
You should set the face recognion terminal's Wiegand direcon as Input to connect to a
Wiegand card reader. If connects to an access controller, you should set the Wiegand direcon as
Output to transmit authencaon informaon to the access controller.
●
For details about Wiegand
direcon sengs, see Set Wiegand Parameters .
●
Do not wire the device to the electric supply directly.
4.3 Wire Secure Door Control Unit
You can connect the terminal with the secure door control unit.
The wiring diagram is as follows.
Figure 4-2 Secure Door Control Unit Wiring
Note
The secure door control unit should connect to an external power supply separately. The suggested
external power supply is 12V, 0.5A.
4.4 Wire Fire Module
4.4.1 Wiring Diagram of Door Open When Powering O
Lock Type: Anode Lock, Magnec Lock, and Electric Bolt (NO)
Security Type: Door Open When Powering O
Scenario: Installed in Fire Engine Access
DS-K1T341C Series Face Recognion Terminal User Manual
18

HIKVISION DS-K1T341CMFW Specifications

General

Type	Face recognition terminal
Face capacity	3000
Product color	Black, Grey
Cards capacity	3000 cards
Event capacity	150000
Wiegand interface	Yes
Fingerprint reader	-
Authentication type	Access chip/card, Face recognition
Fingerprint sensor type	Optical
Face recognition accuracy	99 %
Face recognition distance	1 - 2 m
Face recognition duration	0.2 s
Access chip/card reader type	Contactless
International Protection (IP) code	IP65
Display type	LCD
Screen shape	Flat
Display diagonal	4.3 \
Maximum resolution	272 x 480 pixels
Touchscreen technology	Capacitive
Sensor type	CMOS
Total megapixels	2 MP
Front camera type	Dual camera
Operating system installed	Linux
Ethernet LAN data rates	10, 100 Mbit/s
Input current	2 A
Input voltage	12 - 24 V
Power consumption (typical)	10 W
Operating temperature (T-T)	-30 - 60 °C