EasyManuals Logo

HIKVISION DS-K1T341CMFW User Manual

HIKVISION DS-K1T341CMFW
218 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #189 background imageLoading...
Page #189 background image
The maximum transmission unit (MTU) of the network interface.
6.
Click Save.
Set Network Parameters
Aer adding the access control device, you can set the device log uploading mode, and create ISUP
account via wired network.
Set Log Uploading Mode
You can set the mode for the device to upload logs via ISUP protocol.
Steps
1.
Enter the Access Control module.
2.
On the
navigaon bar on the le, enter Advanced Funcon → More Parameters .
3.
Select an access control device in the device list and enter Network → Uploading Mode .
4.
Select the center group from the drop-down list.
5.
Check Enable to enable to set the uploading mode.
6.
Select the uploading mode from the drop-down list.
-
Enable N1 or G1 for the main channel.
-
Select Close to disable the main channel.
7.
Click Save.
Create ISUP Account in Wired
Communicaon Mode
You can set the account for ISUP protocol in wired communicaon mode. Then you can add
devices via ISUP protocol.
Steps
Note
This funcon should be supported by the device.
1.
Enter the Access Control module.
2.
On the navigaon bar on the le, enter Advanced Funcon → More Parameters .
3.
Select an access control device in the device list and enter Network → Network Center .
4.
Select the center group from the drop-down list.
5.
Select the Address Type as IP Address or Domain Name.
6.
Enter IP address or domain name according to the address type.
7.
Enter the port number for the protocol.
DS-K1T341C Series Face Recognion Terminal User Manual
173

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the HIKVISION DS-K1T341CMFW and is the answer not in the manual?

HIKVISION DS-K1T341CMFW Specifications

General IconGeneral
TypeFace recognition terminal
Face capacity3000
Product colorBlack, Grey
Cards capacity3000 cards
Event capacity150000
Wiegand interfaceYes
Fingerprint reader-
Authentication typeAccess chip/card, Face recognition
Fingerprint sensor typeOptical
Face recognition accuracy99 %
Face recognition distance1 - 2 m
Face recognition duration0.2 s
Access chip/card reader typeContactless
International Protection (IP) codeIP65
Display typeLCD
Screen shapeFlat
Display diagonal4.3 \
Maximum resolution272 x 480 pixels
Touchscreen technologyCapacitive
Sensor typeCMOS
Total megapixels2 MP
Front camera typeDual camera
Operating system installedLinux
Ethernet LAN data rates10, 100 Mbit/s
Input current2 A
Input voltage12 - 24 V
Power consumption (typical)10 W
Operating temperature (T-T)-30 - 60 °C

Related product manuals