EasyManuals Logo

HIKVISION DS-K1T341CMFW User Manual

HIKVISION DS-K1T341CMFW
218 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #8 background imageLoading...
Page #8 background image
Cauons:
Do not drop the device or subject it to physical shock, and do not expose it to high
electromagnesm radiaon. Avoid the equipment installaon on vibraons surface or places
subject to shock (ignorance can cause equipment damage).
Do not place the device in extremely hot (refer to the specicaon of the device for the detailed
operang temperature), cold, dusty or damp locaons, and do not expose it to high
electromagnec radiaon.
The device cover for indoor use shall be kept from rain and moisture.
Exposing the equipment to direct sun light, low venlaon or heat source such as heater or
radiator is forbidden (ignorance can cause re danger).
Do not aim the device at the sun or extra bright places. A blooming or smear may occur
otherwise (which is not a malfuncon however), and aecng the endurance of sensor at the
same me.
Please use the provided glove when open up the device cover, avoid direct contact with the
device cover, because the acidic sweat of the ngers may erode the surface coang of the device
cover.
Please use a so and dry cloth when clean inside and outside surfaces of the device cover, do
not use alkaline detergents.
Please keep all wrappers
aer unpack them for future use. In case of any failure occurred, you
need to return the device to the factory with the original wrapper. Transportaon without the
original wrapper may result in damage on the device and lead to addional costs.
Improper use or replacement of the
baery may result in hazard of explosion. Replace with the
same or equivalent type only. Dispose of used baeries according to the instrucons provided by
the
baery manufacturer.
Biometric recognion products are not completely applicable to an-spoong environments. If
you require a higher security level, use
mulple authencaon modes.
Input voltage should meet both the SELV (Safety Extra Low Voltage) and the Limited Power
Source with 100~240 VAC or 12 VDC according to the IEC60950-1 standard. Please refer to
technical
specicaons for detailed informaon.
DS-K1T341C Series Face Recognion Terminal User Manual
vii

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the HIKVISION DS-K1T341CMFW and is the answer not in the manual?

HIKVISION DS-K1T341CMFW Specifications

General IconGeneral
TypeFace recognition terminal
Face capacity3000
Product colorBlack, Grey
Cards capacity3000 cards
Event capacity150000
Wiegand interfaceYes
Fingerprint reader-
Authentication typeAccess chip/card, Face recognition
Fingerprint sensor typeOptical
Face recognition accuracy99 %
Face recognition distance1 - 2 m
Face recognition duration0.2 s
Access chip/card reader typeContactless
International Protection (IP) codeIP65
Display typeLCD
Screen shapeFlat
Display diagonal4.3 \
Maximum resolution272 x 480 pixels
Touchscreen technologyCapacitive
Sensor typeCMOS
Total megapixels2 MP
Front camera typeDual camera
Operating system installedLinux
Ethernet LAN data rates10, 100 Mbit/s
Input current2 A
Input voltage12 - 24 V
Power consumption (typical)10 W
Operating temperature (T-T)-30 - 60 °C

Related product manuals