HIKVISION DS-K1T342MX

Device Type
Main Card Reader
You can congure the device card reader's parameters. If you select main card reader, you
need to congure the following parameters: Card Reader Type, Card Reader Descripon,
Enable Card Reader, Authencaon, Recognion Interval (s), Minimum Card Swiping
Interval (s), Max. Authencaon Failed Aempts Alarm/Alarm of Max. Failed Aempts,
Enable Tampering Detecon and Enable Card No. Reversing.
Sub Card Reader
You can congure the connected peripheral card reader's parameters. If you select sub
card reader, you need to congure the following parameters: Card Reader Type, Card
Reader Descripon, Enable Card Reader, Authencaon, Recognion Interval (s), Max.
Authencaon Failed Aempts Alarm/Alarm of Max. Failed Aempts, Enable Tampering
Detecon, Communicaon with Controller Every (s) and Max. Interval When Entering
Password (s).
Card Reader Type
Get card reader type.
Card Reader Descripon
Get card reader descripon. It is read-only.
Enable Card Reader
Enable the card reader's funcon.
Authencaon
Select an authencaon mode according to your actual needs from the drop-down list.
Recognion Interval
If the interval between card presenng of the same card is less than the congured value, the
card presenng is invalid. The interval me range is from 0 to 255 seconds (When set to 0, it
means that recognion interval is not enabled, and the same authencaon can be used for
unlimited mes).
Authencaon Interval
You can set the authencaon interval of the same person when authencang. The same
person can only authencate once in the congured interval. A second authencaon will be
failed.
Max. Authencaon Failed Aempts Alarm/Alarm of Max. Failed Aempts
Enable to report alarm when the card reading aempts reach the set value.
Enable Tampering Detecon
Enable the an-tamper detecon for the card reader.
Enable Card No. Reversing
The read card No. will be in reverse sequence aer enabling the funcon.
DS-K1T342 Series Face Recognion Terminal User Manual
100